News und Informationen rundem Metallfedern
Spring systems are spring-technical applications made up of several individual springs, which together realize special tasks. These individually designed spring systems can be designed for a wide variety of applications. By selecting and arranging different springs, practically every desired force
Before interpreting the Compression spring It should basically be clarified whether the intended type of stress is static, quasi-static or dynamic. Static or quasi-static stress Time-constant (resting) load or time-changing load with less than 10,000 strokes in total or small
Safety elements are small, almost inconspicuous machine components that are used in almost every construction. The form-fitting components act as guide elements to protect and limit other machine parts against axial play. The security elements are available in many designs.
When the metal spring is tensioned, work is done, which is then released again when the tension is released. The spring work (W) always results as the area below the spring characteristic. The suspension behavior of steel springs can be
Compression springs, extension springs and torsion springs are typical C-parts: They are not the focus of the procurement process, but are installed in almost all technical applications. The requirements for the spring design are very versatile and individual. Compressive, tensile
How is a extension spring manufactured, what influence do extension spring designs, loop shapes, spring characteristics and spring materials have, and what do technical terms such as preload, relaxation, yield strength and dynamic loading mean for a tension spring? In
In metal springs, a loss of force occurs under permanent tension and higher temperatures, which is called relaxation. This loss of force increases with increasing temperature and load duration. This loss of force is given as a percentage of the
Extension springs by the meter are tension spring strands without eyelets with a total length of 100 cm. The tension springs sold by the meter can be cut individually to any desired length. In order to enable the eyelets to
With conical compression springs, the diameter of the changes Design towards the ends, that is, gets bigger or smaller. They are mainly used when the installation space is limited in the axial direction. The specialty: the coils of conical compression
Hookesche’s law describes the elastic deformation of solids in a linear special case of the Elasticity Act. In this process, the elastic force of the body changes with stretching or squeezing. When applying compression springs, extension springs and torsion springs